BRC A66 Concrete Reinforcement Mesh, 6mm Wire, 200mm Pitch, 2.4m x 4.8m

BRC A66 Steel Mesh

The BRC A66 Reinforcement Mesh provides essential structural integrity for light-duty concrete applications through a precision-welded grid of high-yield ribbed steel. This standard reinforcement fabric meets the requirements for residential and commercial flooring where crack control and load distribution are primary concerns.

Built for the Job

Engineered for site-cast concrete projects, this structural material facilitates rapid installation compared to traditional loose rebar tying. The 200mm square pitch ensures uniform strength across the entire slab surface, making it the standard choice for domestic driveways and garden paths. Site supervisors rely on the consistent 6mm wire gauge to maintain the design thickness of the concrete cover while preventing shrinkage cracks during the curing process.

• Reinforcing light-duty floor slabs in residential outbuildings and garages.

• Providing structural support for pedestrian walkways and paved areas.

• Acting as a temperature and shrinkage reinforcement layer in larger concrete pours.

Product Highlights

High-Yield Ribbed Wire

The cold-rolled steel features a ribbed profile that significantly improves the mechanical bond between the metal and the concrete matrix.

Precision Welded Joints

• Resistance-welded intersections ensure the grid maintains its dimensions during heavy foot traffic and concrete pouring.
• Standard 200mm x 200mm spacing allows for efficient aggregate flow through the mesh.

Technical Specifications

What’s Included

• 1 x BRC A66 Reinforcement Sheet (11.52 square meters total coverage)

On-Site & Workshop Notes

• Maintain a minimum overlap of 400mm or two full mesh squares between adjacent sheets to ensure structural continuity.

• Utilize concrete spacers or plastic stools to keep the welded fabric at the correct depth, typically in the top third of the slab.

• Store the steel sheets on level ground and keep them free from excessive rust, oil, or mud to ensure maximum adhesion with the wet mix.

• Cutting should be performed using heavy-duty bolt cutters or an angle grinder with a suitable metal cutting disc.