Standard UPVC Gutter Angle, 90 Degree, UV Resistant

UPVC Gutter Angle

The Standard UPVC Gutter Angle provides a reliable 90-degree change in direction for roof drainage systems. This fitting ensures efficient rainwater management by connecting two gutter lengths at corners. It suits both residential and commercial roofing projects requiring durable, weather-resistant components.

Built for the Job

Contractors use this corner fitting to navigate the perimeter of a building while maintaining consistent water flow. The component features pre-fitted rubber seals that prevent leaks at the most vulnerable points of the gutter run. It handles high-volume runoff during heavy storms without overflowing. The design accommodates standard half-round gutter profiles commonly found on Kenyan construction sites. This fitting withstands the intense heat of direct sunlight without warping or becoming brittle. It simplifies complex roof layouts by providing a secure junction for intersecting rooflines. Plumbers and roofers rely on this part for its consistent fit and long-term structural integrity.

• Connecting gutter runs at external and internal building corners.

• Directing rainwater toward downpipe outlets in gravity-fed systems.

• Retrofitting existing drainage setups to improve water collection.

Product Highlights

High-Impact UPVC Build

The unplasticized polyvinyl chloride material offers superior resistance to corrosion and chemical degradation.

Advanced Seal Technology

• Integrated EPDM rubber gaskets ensure a watertight compression fit.
• Retention clips hold the gutter securely against the seal during thermal movement.

UV Stabilization

A specialized coating prevents discoloration and cracking caused by prolonged ultraviolet exposure.

Technical Specifications

What’s Included

• 1 x 90-Degree Gutter Angle Fitting with Pre-installed Seals

On-Site & Workshop Notes

• Apply a silicone-based lubricant to the gaskets to ease the insertion of the gutter lengths.

• Observe the expansion gap markers inside the fitting to allow for material movement during temperature changes.

• Place a fascia bracket within 150mm of the corner to provide necessary structural support.

• Ensure the gutter ends are cut square and deburred before sliding them into the corner piece.