Coninx External Gutter End Cap, 125mm uPVC, UV Resistant

Coninx Gutter End Cap

The Coninx External Gutter End Cap provides a secure, watertight seal at the termination point of a roof drainage run. This component prevents water from bypassing the gutter system and damaging the building fascia or foundation. Manufactured from high-grade uPVC, this fitting withstands harsh environmental conditions and heavy rainfall cycles. It is designed specifically for the standard 125mm profile used in residential and commercial construction across the region.

Built for the Job

Contractors install this stop end at the highest point of a gutter run or at any termination point where a downpipe is not located. It manages the flow of rainwater effectively by containing it within the trough. Site supervisors specify these fittings because they handle the thermal expansion and contraction cycles common in tropical climates. The external fitment allows for a clean finish on the outside of the gutter profile. This design facilitates easy inspection and maintenance without needing to dismantle the entire drainage run. Plumbers frequently use this part in rainwater harvesting setups to ensure maximum collection efficiency by preventing leaks at the run ends.

• Closing off gutter runs on residential gable ends and eaves.

• Terminating drainage systems on commercial warehouse roofing.

• Managing water flow in multi-unit housing development projects.

Product Highlights

UV Stabilized uPVC

The material contains specific chemical additives to prevent brittleness and cracking caused by prolonged sunlight exposure.

Watertight Sealing

• Features a pre-fitted EPDM rubber gasket for a leak-proof joint.
• Requires no solvent cement, allowing for thermal movement.
• Snap-fit design ensures a secure grip on the gutter profile.

Technical Specifications

What’s Included

• 1 x Coninx 125mm External Gutter End Cap

• Integrated Sealing Gasket

On-Site & Workshop Notes

• Ensure the gutter edge is cut square and deburred before fitting the stop end to prevent gasket damage.

• Apply a small amount of silicone lubricant to the rubber seal to assist with thermal expansion during high-temperature periods.

• This fitting is specifically engineered for the Coninx 125mm profile and may not seat correctly on non-compatible gutter brands.

people also view

• Coninx Internal Gutter End Cap, uPVC Rainwater Fitting
• Coninx External Gutter Angle, 90° uPVC Rainwater Fitting
• Standard GI 3/4 Inch Galvanized Iron Cap Plug
• Coninx Gutter Internal Angle 90° uPVC Rainwater Fitting
• Generic GI 1 Inch Cap Plug, Galvanized Iron, Male Threaded