Kidani 30 Gauge Corrugated Iron Sheet 2.5m Glossy Finish

Kidani Corrugated Roofing Sheet

The Kidani 30 Gauge Sheet provides a reliable structural barrier for residential and light commercial roofing applications. This 2.5-meter cold-rolled steel panel features a traditional corrugated profile designed for maximum water shedding and structural rigidity. The glossy finish enhances thermal reflection and protects the substrate against environmental oxidation.

Built for the Job

Contractors specify this 30-gauge material for projects requiring a balance of lightweight handling and weather resistance. The 2.5m length is optimized for standard timber or steel truss spacings, reducing the need for excessive cutting on-site. The corrugated design creates natural air channels that assist in temperature regulation when installed with proper ventilation. This product is frequently utilized for main roof structures, perimeter fencing, and durable temporary site hoardings. The high-gloss coating ensures that debris and organic matter slide off easily during rain cycles, maintaining the integrity of the drainage system.

• Residential roofing for single-story dwellings and extensions.

• Construction of secure site boundaries and temporary sheds.

• Agricultural outbuildings requiring cost-effective cladding.

Product Highlights

Weatherproof Coating

The glossy protective layer prevents moisture penetration and resists UV-induced chalking over time.

Structural Profile

• Standard pitch corrugation facilitates high-volume water runoff.
• Increased longitudinal strength compared to flat sheets of the same gauge.

Technical Specifications

What’s Included

• 1 x 2.5m 30 Gauge Corrugated Iron Sheet (Glossy Finish)

On-Site & Workshop Notes

• Use specialized roofing nails or self-drilling screws equipped with EPDM washers to ensure a watertight seal at the crown of the corrugation.

• Maintain a minimum overlap of 1.5 to 2 corrugations depending on the local wind load and roof pitch requirements.

• Always wear protective gloves when handling these metal panels to prevent injury from sharp factory-cut edges.

• Store the units on a slight incline in a dry area to prevent water entrapment between stacked sheets before installation.