Powermax 2ft Twin Diffused
The Powermax 2ft Twin Fitting provides a standardized housing for dual 600mm T8 LED tubes in commercial and industrial environments. This surface-mounted luminaire utilizes a high-transmittance prismatic diffuser to minimize glare and optimize light distribution across the work plane. It supports direct-to-mains wiring configurations, eliminating the need for external ballasts or complex control gear. The chassis consists of cold-rolled steel with a high-reflectance powder-coated finish. This construction ensures structural rigidity and efficient thermal management for the internal components. The unit integrates G13 bi-pin lampholders with a secure rotary lock mechanism to maintain electrical contact under vibration.
Key Features
-
Optical Diffusion System
The UV-stabilized prismatic polystyrene diffuser ensures uniform light dispersion while preventing material yellowing over extended operational cycles. -
Chassis Construction
- 0.5mm gauge cold-rolled steel body
- Multi-stage epoxy powder coating for corrosion resistance
- Integrated earth bonding point for electrical safety
-
Electrical Configuration
Pre-wired internal circuitry supports single-ended T8 LED tubes with a maximum load capacity of 20W per lamp holder. -
Installation Mechanics
- Rear and end-cap knockouts for 20mm conduit entry
- Screw-fix mounting holes spaced for standard BESA box alignment
- Large format terminal block for 2.5mm² cable loops
Specifications
| Feature | Specification |
|---|---|
| Nominal Length | 600mm (2 Feet) |
| Lamp Configuration | Twin (2 x T8 Tubes) |
| Base Type | G13 Bi-pin |
| Input Voltage | 220-240V AC, 50/60Hz |
| Ingress Protection | IP20 (Indoor Use) |
| Diffuser Material | Prismatic Polystyrene |
| Body Material | Powder Coated Steel |
| Mounting Type | Surface Mounted / Suspended |
What’s in the Box
-
1 x Powermax 2ft Twin Diffused Chassis
-
1 x Prismatic Polycarbonate Diffuser
-
2 x End Caps with G13 Lampholders
-
1 x Installation Component Kit
Why Choose Powermax 2ft Twin Diffused
-
The high-reflectance internal tray increases light output ratio by directing lumens downward through the prismatic controller.
-
Tool-free diffuser removal via spring-loaded clips facilitates rapid lamp replacement and reduces maintenance labor costs.
-
A low-profile 60mm depth profile allows for installation in areas with restricted ceiling heights without compromising light quality.
-
The steel chassis acts as a passive heat sink to extend the operational lifespan of the installed LED components.
Kamau Njuguna (verified owner) –
Good quality fitting for my small workshop in Industrial Area. The prismatic cover really helps to spread the light evenly without that sharp glare you get with open tubes. It was easy to install and looks much neater than the old battens I had before.
Faith Mutua (verified owner) –
Received the order on time. The fittings are sturdy and fit the 2ft tubes perfectly. Good value for money compared to what I saw in town shops.
Evans Omondi (verified owner) –
Used these for a client’s store room project in Westlands. Since they are LED-ready, the wiring was very straightforward—no need to mess around with starters or ballasts. The build is decent, though you have to be careful with the side clips when snapping the diffuser back on so they don’t crack. Overall, a solid choice for indoor lighting where you need the tubes protected from dust.