PPR 25mm Female Elbow, Brass Threaded, PN25 Pressure Rated

25mm PPR Female Fitting

The PPR 25mm Female Elbow serves as a critical transition point within a polyfusion plumbing network for connecting threaded metal fixtures. This 90-degree component utilizes a high-grade brass insert to facilitate secure attachments for taps, valves, and mixers. It provides a pressure-resistant bridge between thermoplastic piping and traditional hardware.

Built for the Job

Plumbers and facility managers rely on this fitting during the second-fix stage of installations in residential and commercial projects. The reinforced internal threads allow for the direct mounting of bib taps and shower mixers without risking the structural integrity of the plastic line. It withstands the mechanical stress of tightening metal fittings due to the knurled design of the brass core. This transition piece is essential for hot and cold water distribution where high thermal stability is required. The smooth internal bore minimizes friction loss and prevents the accumulation of scale or calcification over long-term use in hard water areas.

• Transitioning from 25mm PPR mains to 1/2-inch threaded fixture points.

• Installation of isolation valves and manifolds in HVAC systems.

• Secure mounting of wall-hung bathroom accessories and kitchen mixers.

Product Highlights

PN25 Pressure Rating

The component supports operational pressures up to 2.5 MPa, making it suitable for high-rise plumbing.

Durable Brass Insert

• Deep knurling prevents the metal insert from spinning inside the PPR housing.
• Nickel-plated finish offers superior resistance to oxidation and chemical corrosion.

Technical Specifications

What’s Included

• 1 x 25mm Female Threaded PPR Elbow Fitting

On-Site & Workshop Notes

• Set the socket fusion tool exactly to 260°C before attempting the heat-welding process.

• Mark the 16mm insertion depth on the pipe to ensure the joint does not restrict the internal flow path.

• Apply PTFE tape or thread sealant to the metal threads to ensure a water-tight seal when connecting fixtures.

• Hold the joint steady for at least 10 seconds after fusion to allow the plastic to set without misalignment.